DIGGERS™ Timber Cleaner (Concentrated Oxalic Acid) cleans new timber and restores old greying timber prior to oiling, staining and painting.

TYPICAL USES

• Timber cleaning / preparation / restoration
• Timber bleaching

FEATURES

• Concentrated formula – makes 5 litres
• Effective, strong and fast acting
• Reduces the need for sanding on wooden finishes

How to Use DIGGERS™ Timber Cleaner (Concentrated Oxalic Acid)

• Prepare the area – Remove excess dirt and debris from the timber surface. Protect surrounding areas such as metal fittings, paintwork, or plants with plastic sheeting or by wetting them before use.
• Dilute the solution – Wearing gloves and eye protection, mix 1 part DIGGERS™ Timber Cleaner with 4 parts water in a plastic container.
• Apply to timber – Wet the timber surface with clean water. Liberally scrub the diluted solution onto the timber using a stiff scrubbing brush. Allow the solution to penetrate for 10–20 minutes.
• Rinse thoroughly – Rinse the timber well with fresh water to remove all cleaner residues. Failure to rinse completely may cause discolouration, particularly under clear finishes.
• Allow to dry – Leave the timber to dry for 24–48 hours before painting, staining, or oiling. To check dryness, tape a small piece of plastic wrap to the timber surface. If moisture forms underneath within 2 hours, allow additional drying time and retest.

 
Frequently Asked Questions (FAQs)

Q: What does DIGGERS™ Timber Cleaner do?
A: It cleans and restores timber surfaces by removing dirt, stains, and greying, preparing the wood for oiling, staining, or painting.

Q: What is DIGGERS™ Timber Cleaner made of?
A: DIGGERS™ Timber Cleaner is a concentrated oxalic acid solution, formulated to clean, brighten, and restore timber surfaces. Its concentrated formula makes a large amount of cleaning solution, so a little goes a long way.

Q: Can DIGGERS™ Timber Cleaner be used on both new and old timber?
A: Yes. It’s suitable for cleaning new timber before finishing and for restoring weathered or greying timber to its natural colour.

Q: How much product do I need?
A: The concentrated formula makes up to 5 litres of cleaning solution when diluted as directed.

Q: Do I need to sand the timber after using DIGGERS™ Timber Cleaner?
A: In many cases, sanding may not be necessary, as the cleaner helps remove surface imperfections and contaminants. However, light sanding can be done if a smoother finish is desired.

Q: Can I use this product near plants or metal fittings?
A: Yes, but protect or pre-wet surrounding metal and plants before use, and rinse them immediately after cleaning to prevent damage.

Q: Will this product bleach my timber?
A: DIGGERS™ Timber Cleaner has a mild bleaching effect that brightens timber and restores its natural appearance.

Q: What happens if the cleaner is left on too long?

A: Leaving it on for longer than 20 minutes may cause the timber surface to become “furry.” Always rinse within the recommended time.